Brainboxes ES-020 Instrukcja Obsługi Strona 10
- Strona / 57
- Spis treści
- BOOKMARKI
Oceniono. / 5. Na podstawie oceny klientów
ES Range Product Manual
Version 2.8
© Copyright Brainboxes Limited 2012
Page 10 of 57
4. Installation
PLEASE READ CAREFULLY
The “Setup” program will install the Boost.LAN Manager application.
Boost.LAN Manager application is the graphical user interface for locating and configuring all
Brainboxes‟ Ethernet to Serial devices in Windows.
Boost.LAN is the COM ports device driver that you will use in Windows to access your ES
ports as standard Windows COM ports. You need Boost.LAN Manager to install the
Boost.LAN COM ports driver.
Neither Boost.LAN Manager or Boost.LAN is required if:
1. Your application speaks directly to IP addresses. (E.g. using telnet or Win sock
communication)
2. You want to remotely change the settings of the ES device via web page access
Follow the instructions below to start the installation process.
If you have any issues with installation, see Section 15
Connecting Your ES Device
1. Connect the ES device to your local network by using an Ethernet cable and plugging into the
Ethernet port connection. The ES Ethernet port will automatically detect the polarity of the
Ethernet connection so both a straight through or crossover Ethernet cable can be used.
2. Connect the power adapter or a DC power line (5-30V) to the ES power terminal block or jack
connection.
If using the Brainboxes PW-644 power supply ensure:
a. the wire marked ―-― is connected to V-
b. the wire marked ―+‖ is connected to V+
3. Confirm the device beeps as it is turned on.
4. When the Status LED starts shows a solid green light the device is ready to use.
5. Connect the serial cable from your serial device to the port terminal block or DB 9 connector
(depending on ES model) on the ES device. See Section 18 for pin outs.
Make a note of device MAC address (on the side of the ES device, XX-XX-XX-XX-XX) as you will
need it to identify the device on your network later.
- ES - Range Product Manual 1
- Contents 2
- 1. Introduction 5
- 2. Before You Start 6
- Requirements 7
- Supported Operating Systems 7
- 3. Hardware Features 8
- Network IP Addressing 9
- Default Settings 9
- 4. Installation 10
- 6. Testing the ES device 16
- 7. Advanced Configuration 17
- Port Settings 18
- Changing your COM label 19
- RS422/485 Settings 20
- RS485 Full Duplex (ES-357) 21
- Alternate Access Methods 26
- Proxy Server Settings 26
- Device Swapping 26
- Remote Access 26
- Serial Tunneling 28
- UPnP on/off 30
- Transmission Interval 31
- 8. Web Page Interface 32
- 9. Security 34
- MAC Address restriction 35
- Authentication Method 36
- Exporting Device Settings 37
- Importing Device Settings 38
- 11. Rebooting Device 40
- Manual Hard Restore 41
- 13. Firmware Upgrade 42
- 14. Uninstallation 44
- 18. Technical Specifications 51
- LED indicators 52
- Physical 52
- Company Accreditation 54
- RoHS Compliance 55
- 20. Copyright 56
- 21. Version History 57
Uniden Telefoni manuali utente
Partendo da T
Komentarze do niniejszej Instrukcji