Brainboxes ES-020 Instrukcja Obsługi Pobierz pdf (Strona 9)

ES Range Product Manual

Version 2.8

Page 9 of 57

For information on power supplies and pin outs please see Section 18 Technical Specifications.

LED Information

Status LED

Green Light On

Flashing Green

Device Ready

Flashing Red & Yellow

Changing Settings

Flashing between Green & Red

Querying IP

Flashing between Green & Red

IP Problem

Flashing Green/Red

Performing Hard Reset

Flashing between Green & Yellow

Problem during initialization (e.g.

Firmware Problem)

Serial Port LED

Green light on

Port Open

Flashing light on

Data RX/TX

Ethernet LED

Green light on

Link established

Flashing Green

Data RX / TX

Network IP Addressing

The ES device is shipped in DHCP Mode.

 On connecting to the network, the device automatically checks if it is connected to a DHCP

Server. If this is the case, the DHCP server will allocate an IP address automatically to the ES

device.

 If no DHCP Server is detected (e.g. you have the ES device plugged directly into the PC), the

ES device will default to an IP address of 192.168.127.254 within 60 seconds. Please ensure

the PC you‟re using for configuration can communicate with the 192.168.127.xxx IP range by

setting the Ethernet port the ES device is plugged into, to an IP address in the same subnet.

 If you are using the default IP address with no DHCP server, you can change to a static IP

address to avoid having to wait 60 seconds for the default address of 192.168.127.254

Default Settings

Network Setting

Device Network Address

DHCP Mode

Web Server Port

Port Settings

RS232 Port

RS422/485 Port

Baudrate

115200

Databits

Stop bits

Parity

Flow Control

None

Duplex mode

Full Duplex

Protocol Settings

Telnet + COM port control

Mode (Server)

Telnet + COM port control Mode

(Server)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 56 57

Komentarze do niniejszej Instrukcji

Brak uwag

Brainboxes ES-020 Instrukcja Obsługi Strona 9

Komentarze do niniejszej Instrukcji